FIFINE BM88 Low Profile Boom Arm Installation and Customization Tips

FIFINE BM88 low-profile mic arm's compact design maximizes desk space while providing ample reach, ideal for positioning your microphone comfortably without obstruction. Here are practical installation tips from @kyle-humber for your BM88.

Optimal Base Placement

For maximum stability, start by placing the arm's base securely at the edge of your desk. The padded ring protects your surface from scratches and offers strong grip without adhesion. You can also consider positioning the arm so the mic extends from below your monitor rather than from the side - this saves space and avoids interference with mouse movement.

Tension Customization

Use the included hex wrench to fine-tune the desktop boom arm stand FIFINE BM88's tension. If your microphone is heavier, tighten the main pivot and vertical hinge just enough to hold it securely without straining the mechanism.

Cable Management Mastery

Thread your microphone cable through the integrated channel before attaching the mic. For mics with rear-facing ports, using a right-angled USB cable is a good way to keep the connection flush and stress-free. Loop any excess cable loosely beneath the desk to avoid tugging.

Microphone Positioning

Adjust the ball head so the microphone points naturally toward your mouth. For side-address mics, rotate the mount for ideal alignment. Test your microphone's position while speaking normally to ensure consistent audio levels and minimal handling noise.

Workflow Integration

Swing the arm smoothly into your ideal recording position - often just below eye level and slightly off to the side. When not in use, retract it cleanly under your monitor to free up desk space.

With these tips, mic arm FIFINE BM88 will deliver both performance and polish, elevating your audio setup without compromising your workspace.